Security and monitoring

Cellular or Wi-Fi: how your alarm calls for help

An alarm is only useful if its signal gets out of the house. There are three ways it can travel, and they behave very differently in a storm.

Topic
Security
Reading time
About 5 minutes
Updated
Related service
Security & Monitoring

The short version

  • A cellular alarm has its own radio. It does not need your internet or a phone line.
  • A battery in the panel keeps the alarm and that radio running through an outage.
  • Cameras are different: they need your Wi-Fi and power to send video.
  • If your alarm still dials out over a phone line, it is worth having it looked at.

Three ways a signal leaves the house

When a sensor trips, the panel has to tell the monitoring center. Over the years there have been three ways to do that.

The phone line

For decades an alarm panel dialed out over the home's copper phone line, like a fax machine. It worked, but it had two weaknesses. The line usually ran down the outside of the house, where it could be cut. And the copper network itself is being retired: many homes now get "phone service" from a box plugged into the internet router, which stops working when the internet or the power does. An alarm that still depends on a phone line is depending on something that may no longer be what it was.

The home internet

A panel can also send its signal over your broadband connection, through the router, by cable or by Wi-Fi. This is fast and carries plenty of information. Its weakness is that it has many links, and any one of them can drop: the router can lose power, the modem can lock up, the internet provider can have an outage, a tree can take the line down on your road.

A cellular radio in the panel

The third way is a small cellular radio built into the alarm panel. It talks to the same cell towers as your phone, on its own account, with no connection to your router or your phone line. There is no cable outside to cut and nothing for a household internet outage to interrupt.

Two ways an alarm signal leaves a houseA house on the left with an alarm panel inside. One dotted line goes from the panel up to a cell tower and on to a monitoring center on the right. A second line runs from a router in the house along the road to the same building.
  1. The alarm panel, with its own backup battery.
  2. Cellular. The panel's own radio to a cell tower. It does not touch your router.
  3. Home internet. Through your router and the line along your road. It stops if either loses power or the line comes down.
  4. The monitoring center, staffed around the clock.
A diagram, not a drawing of any customer's home.

What happens when the power goes out

This is where the difference shows. Picture a summer thunderstorm that takes the power out on your road for the evening.

Part of the systemPower outInternet out
Alarm panel with battery backupKeeps running on its batteryNot affected
Cellular radio in the panelKeeps running on the same batteryNot affected
Door, window and motion sensorsKeep working; wireless ones have their own batteriesNot affected
Router and modemOff, unless they have their own backup powerOn, but with nothing to connect to
Cameras and video doorbellOff, unless they and the network have backup powerCannot send video out of the house
Alarm that reports by internet onlyCannot report once the router is offCannot report

So with a cellular panel and a healthy backup battery, a tripped door sensor during that storm still reaches the monitoring center. How long the battery lasts depends on the panel and the age of the battery, and batteries do wear out. A panel will tell you when its battery is low; do not ignore that message.

The systems we install on Alarm.com communicate over a cellular connection and have battery backup, so the alarm does not depend on your home internet. Some also use the home internet as a second path. We go over what your own panel does when we set it up.

What if someone breaks the panel?

A fair question: if the panel is by the door, could an intruder smash it during the entry delay, before it sends anything?

Alarm.com has a feature built for this. In plain terms, the service notices that an entry delay started and then the panel went silent, and treats that silence as an alarm. It is available on eligible plans and equipment, so ask whether your system has it. We can tell you for any system we install.

So what is the Wi-Fi for?

Video. A cellular alarm radio is built to send small, important messages reliably. Camera footage is thousands of times more data than "back door opened", and it travels over your home internet.

That makes your network part of the security system as soon as you add a camera or a video doorbell. A camera at the far end of the house on one bar of signal will drop frames, miss clips and go offline at the worst moment. Before adding cameras it is worth knowing whether the Wi-Fi actually reaches where they will hang. See our guide to Wi-Fi in long ranch houses and metal buildings, or the Networking & Wi-Fi page.

If you want cameras to ride through a short outage as well, the modem, router and camera power can be put on a battery backup unit. That keeps them up for as long as its battery lasts, provided your internet provider's own equipment up the road still has power.

Cell signal out in the county

A cellular panel needs a usable signal, and coverage in rural West Tennessee is uneven. Hills, river bottoms and distance from the highway all matter. So does the building: a panel inside a metal shop gets far less signal than one in a frame house.

The good news is that a panel needs much less signal to send a short alarm message than your phone needs to stream a video, and an installer can measure the signal at the spot where the panel will go before anything is mounted. Where it is weak, the usual fixes are moving the panel to a better wall or adding an antenna. That check is part of a good installation, not something you should have to discover afterward.

How to tell what you have now

  • Look at where the panel connects. A phone cord running from the alarm's metal cabinet to a phone jack means it dials out, or once did.
  • Ask your alarm company. "How does my panel communicate, and when was the radio last replaced?" is a reasonable question, and they should be able to answer it.
  • Think about its age. Cellular networks change. The carriers shut down their 3G networks in 2022, and alarm radios that used them had to be replaced. A system nobody has touched in many years may not be reporting at all.
  • Test it. Have the monitoring center put the system on test, trip a sensor, and ask whether the signal arrived.

If you are not sure, we are glad to look. An older system can often keep its wired sensors and gain a current panel and radio; see switching alarm companies.

Written by the team at Security Solutions, Inc. in Brighton, Tennessee. General guidance, not a quote for your house: every home is different, and we would rather look at yours than guess.

What we install

The services behind this guide.

Where we work

We install from our office at 139 N Main St in Brighton, within about 100 miles. The service areas page lists every town and about how long the drive is.

Mike and his team are awesome! We chose them as a local company over the big box companies and have never looked back! We are comfortable leaving knowing we are protected and have 24/7 access to our cameras and alarm system. Highly recommended!

Justin Guinnip, Google review 4 years ago

Free quote

Rather talk it through?

Tell us about the house and we will call you back to set up a free visit. Or skip the form and call the office.

901-476-6918

Security Solutions, Inc.
139 N Main St, Brighton, TN 38011
Toll-free 1-888-280-8775

Request a free quote About a minute

We use these details to reply to your request and for nothing else. Privacy