Networking and Wi-Fi

Wi-Fi in long ranch houses and metal buildings

The internet coming into the house may be fine. The trouble is getting it to the back bedroom, the porch and the shop. That is a different problem, and a faster plan from your provider will not fix it.

Topic
Wi-Fi
Reading time
About 6 minutes
Updated
Related service
Networking & Wi-Fi

The short version

  • Speed is what your provider sells. Coverage is how the house is set up. They are separate problems.
  • Access points wired back to the router beat any number of wireless repeaters.
  • Metal siding and roofing block radio. A metal building needs its own access point inside.
  • Between buildings, use fiber in conduit or a point-to-point wireless link, not a long copper cable.

Why the far end of the house has no signal

A Wi-Fi signal gets weaker with every foot it travels and every wall it passes through. Most routers sit wherever the internet service came into the house, which is usually a corner: the garage wall, a front bedroom, behind the living-room TV. In a compact two-story house that corner is still fairly near everything. In a long single-story house it is at one end of a hallway, with every room at the other end behind six or eight walls.

What those walls are made of matters as much as how many there are.

  • Brick and stone. An interior brick wall, a stone fireplace or a brick exterior wall between the house and the porch takes a large bite out of the signal.
  • Metal. Ductwork, foil-faced insulation, a refrigerator, a steel door and metal roofing reflect radio instead of letting it through.
  • Tile, mirrors and water. A tiled bathroom between the router and the bedroom is a common culprit. So is a large aquarium.
  • Distance outdoors. The porch and the patio are on the other side of the exterior wall, which is the thickest wall in the house.
One router compared with wired access points in a long houseTwo floor plans of the same long house with a metal shop beside it. In the top plan one router sits at the left end and its signal fades before the right-hand rooms. In the bottom plan three access points are wired along the house and a link runs to a fourth inside the shop.
  1. One router, where the internet comes in, at one end of the house.
  2. The far rooms. The signal has faded before it gets here, and it never reaches the metal shop.
  3. Wired access points. Each covers its own part of the house and is cabled back to the router.
  4. A link to the shop: fiber in a conduit, or a point-to-point wireless link.
  5. An access point inside the shop, because the signal cannot get through the metal.
A diagram, not a drawing of any customer's home.

Faster reaches less far

Wi-Fi uses more than one radio band, and they trade speed for reach. The lowest band travels farthest and gets through walls best, but it is slower and crowded with other devices. The higher bands are much faster and reach a shorter distance, with less ability to get through walls. Your phone picks between them by itself.

This is why a speed test beside the router looks wonderful and the same test in the back bedroom does not. It is also why the answer is rarely a more powerful router. A louder router can shout farther, but your phone still has to answer back, and a phone has a small radio.

What fixes it: more access points, wired

The fix is to bring the Wi-Fi closer to where it is used. That means several access points spread through the house, each one covering its own area at a comfortable volume, all broadcasting the same network name so that devices move between them without you noticing.

How those access points connect back to the router is the part that matters most.

ApproachHow it connectsWhat to expect
Plug-in repeaterListens to the router over Wi-Fi and repeats itIt can only repeat the signal it receives, so put where the signal is already weak it repeats a weak signal
Wireless meshUnits talk to each other by radioBetter than a repeater. Each wireless hop still uses up airtime, and it struggles through brick or metal
Wired access pointsA data cable from each one back to the router or a network switchEach access point gets the full connection. The most reliable arrangement, and the one we recommend

A wired access point is a small disc, usually on the ceiling, fed by a single data cable that also carries its power. In a house with an attic, getting that cable to the middle of a hallway ceiling is normally straightforward. In a new build it is trivial, which is why it belongs on every pre-wire list.

How many does a house need? It depends on the length of the house, what the walls are made of and where you want coverage outside, so we would rather measure than guess. As a rough picture, a long ranch usually wants one toward each end and often one in the middle, plus something for the porch or patio.

Where to put them

  • On the ceiling, in the open. Radio spreads out and down from a ceiling. An access point in a cabinet, behind a TV or on the floor behind a couch has lost half its reach before it starts.
  • Near the people, not the equipment. The closet where the internet comes in is a fine home for the router and a poor place for Wi-Fi.
  • Hallways and living areas first. Cover where the phones, tablets and TVs are.
  • One for outdoors. If you want Wi-Fi on the patio or by the pool, an access point made for outdoor use, mounted under the eave, does it right. Outdoor cameras, patio speakers and a porch TV all lean on it.

The shop, the barn and the metal building

A metal building is close to a sealed box as far as radio is concerned. The signal from the house does not get in through steel siding and a steel roof, and a signal made inside does not get out. Standing in the doorway with the roll-up door open, you may get a bar or two. Close the door and it is gone.

So a shop or barn needs two things: a link from the house to the building, and its own access point inside.

Getting the network to the building

  • Fiber in a buried conduit. The best link. Fiber carries data as light, so it has no length limit you will reach on a home property, and because it is glass it does not carry a lightning surge from one building to the other.
  • A point-to-point wireless link. Two small directional radios, one on the house and one on the building, aimed at each other. With a clear line of sight between them this works well over long distances and needs no trench. Trees in full leaf between the two are the usual spoiler.
  • A buried copper data cable. Works over short distances, but ordinary data cable has a length limit of about 328 feet, and copper between two buildings with separate electrical grounds invites damage in a thunderstorm. We prefer one of the first two.

If a trench is being dug for power or water anyway, put a spare conduit in it. That advice is free and it saves a second trench.

Inside the building

Once the link arrives, an access point inside covers the building, and cameras, a garage door controller or a TV can be wired to the same spot. A gate at the end of a long drive is handled the same way: a link to the gate, then whatever needs a connection there.

Coverage is not speed

Two different things get called "bad internet".

  • Slow everywhere, even beside the router, is the service coming into the house. That is between you and your provider, and in parts of the county the choices are limited. We do not sell internet service.
  • Fine beside the router, poor elsewhere, is coverage. That is the house, and it can be fixed.

You can tell them apart in ten minutes. Run a speed test on your phone next to the router and write the number down. Then walk to the back bedroom, the kitchen, the porch and the shop and run it again in each. Where the number collapses or the test will not run, you have a coverage gap.

Why it matters more every year

Ten years ago a weak spot meant a slow laptop. Now the video doorbell, the cameras, the thermostat, the TV in the bonus room and the speakers on the patio all depend on the network, and several of them live at the edges of the house where coverage is worst. A camera that keeps dropping offline is usually a Wi-Fi problem, not a camera problem.

That is why we treat the network as the first thing to get right. The Networking & Wi-Fi page describes how we design it, and Structured Wiring covers getting the cable where it needs to be.

Written by the team at Security Solutions, Inc. in Brighton, Tennessee. General guidance, not a quote for your house: every home is different, and we would rather look at yours than guess.

What we install

The services behind this guide.

Where we work

We install from our office at 139 N Main St in Brighton, within about 100 miles. The service areas page lists every town and about how long the drive is.

Security Solutions has installed my home security system as well as all of my home's hardwired ethernet connections, and most recently my entire outdoor speaker system. Every engagement with SSI and all of their employees has been nothing short of professional and accommodating. They are on time and responsive. I highly recommend this business.

Jes Flesch, Google review 5 years ago

Free quote

Rather talk it through?

Tell us about the house and we will call you back to set up a free visit. Or skip the form and call the office.

901-476-6918

Security Solutions, Inc.
139 N Main St, Brighton, TN 38011
Toll-free 1-888-280-8775

Request a free quote About a minute

We use these details to reply to your request and for nothing else. Privacy