New construction

What to pre-wire in a new home

A wall that is still open is the cheapest it will ever be to wire. Here is what is worth running before the drywall goes up, what can wait, and when to make the call.

Topic
Building
Reading time
About 8 minutes
Updated
Related service
Structured Wiring

The short version

  • Run wire after the plumbing, electrical and ductwork rough-in, and before the insulation.
  • Cable is the small part of the cost. Opening a finished wall later is the big part.
  • Wire for Wi-Fi access points, cameras and TVs even if you buy none of them yet.
  • Where you cannot decide, put in an empty conduit.

Why this happens before the drywall

Low-voltage wiring is the cable that carries data, video, sound and alarm signals, as opposed to the wiring that carries household power. In a framed house, a cable goes from one room to another in minutes: through a hole in a stud, across the attic, down into a box. In a finished house the same run can mean cutting and patching drywall, fishing past insulation and fire blocking, or giving up and running it outside.

That is the whole argument for pre-wiring. The cable itself is a small part of the cost of any system. The labor to get it into a closed wall is the large part. So the question during a build is not "what will we buy?" but "where might we ever want a wire?"

You do not have to buy cameras, speakers or a single piece of equipment to pre-wire. The cables are left coiled and labeled in the wall or ceiling and used when you are ready.

When to call, and when it is too late

The window is short, and it sits in the middle of the build.

  1. With the plans. The best time to talk is before framing, with a set of drawings on the table. Device locations can be marked on the plan and the builder can price the work with everything else.
  2. After the other rough-ins. Low-voltage cable goes in once the plumber, the electrician and the heating and air contractor have run their pipe, wire and duct. That way nobody drills through our cable, and we can keep the proper distance from power wiring.
  3. Before the insulation. Once insulation is in the walls, the easy window has closed. Once the drywall is hung, it is a retrofit.
  4. At trim-out. After paint, the wall plates, speakers, access points and cameras go on, and the system is set up and tested.

If you are already past insulation, it is still worth a call. Attics and crawl spaces leave more options than people expect, and a single-story house is easier than a two-story one.

Data and Wi-Fi: wire the wireless

The most useful cable in a new house is ordinary data cable, the kind sold as Category 6. It carries the network, and with the right equipment it also carries power to small devices such as access points and cameras, so those need no outlet of their own.

Good Wi-Fi comes from access points that are wired back to the router, placed where people use their phones and laptops. That means a data cable to a central spot on the ceiling of each floor, and more for the far end of a long house, a bonus room and the garage. A long ranch house rarely gets by on one. We go into the reasons in the guide to Wi-Fi in long ranch houses and metal buildings.

Then wire the things that should never be on Wi-Fi at all if you can help it: every TV location (two cables each), every desk, and anywhere a game console or streaming box will live. A device on a cable leaves the wireless free for the devices that have no choice.

Where the cables go

Where low-voltage cables run in a new houseA cut-away of a single-story house. Cables run from a wiring panel in a utility room up into the attic and down to an access point on the ceiling, a television, a camera under the eave, a ceiling speaker and a keypad by the door. A dotted conduit leaves the house underground.
  1. The wiring panel, in a closet or utility room, where every cable ends.
  2. A ceiling access point for Wi-Fi.
  3. Each TV location, with a conduit behind it.
  4. A camera under the eave.
  5. A ceiling speaker.
  6. The alarm keypad by the door you use most.
  7. A spare conduit out toward the shop, the gate or whatever comes later.
A diagram, not a drawing of any customer's home.

Every cable runs back to one place. Builders call it a structured wiring panel or media panel; in a larger house it may be a small equipment rack. Put it inside the heated and cooled part of the house, such as a closet or utility room, and not in the attic or the garage, where summer heat is hard on electronics. It needs a power outlet next to it and more room than you think.

Security and cameras

Modern alarm sensors can be wireless, and they work well. Wired contacts on the outside doors are still worth having in a new build, because they are hidden in the frame and have no batteries to change. At a minimum, run cable to where the alarm panel or keypad will go, usually beside the door the family uses most, and to a siren location.

Cameras are where pre-wire pays off most. A wired camera needs one data cable, which carries both the picture and the power. Run one to each spot under the eaves that looks at something you care about: the driveway, the front door, the back door, the side gate. Add one at the doorbell and one in the garage. A cable left coiled in a soffit costs very little. Getting a cable to that same soffit after the house is finished is a much bigger job.

See Security & Monitoring and Security Cameras for what goes on the end of those cables.

Speakers, TVs and the porch

Speaker cable cannot be replaced by wireless in a ceiling. If you think you may ever want music in the kitchen, the primary bedroom, the bath or on the patio, run in-wall rated speaker cable to those ceilings now and bring every run back to one place. The speakers themselves can wait for years.

At each TV location, ask the framer for wood blocking where the mount will go, and ask for a conduit from behind the TV to where the equipment will sit. Connections change every few years, and a conduit lets a new cable be pulled without opening the wall. If the TV is going over a fireplace, decide that early, because the route for the wire is harder there.

For a family room or theater, the surround speaker locations and the subwoofer cable need deciding before drywall too. Our guide to choosing between a theater and a media room covers the layouts.

Do not forget outside. A porch TV wants a data cable and a conduit, the patio wants speaker cable, and the back yard wants Wi-Fi. Power outlets are part of the electrical plan, so mark where they need to be and make sure the electrician and the low-voltage installer are working from the same drawing.

When in doubt, conduit

Nobody knows what cable a house will want in fifteen years. An empty conduit is the honest answer to that. A flexible conduit from the wiring panel up to the attic, and another down to the crawl space or out to the slab edge, means a new cable can reach almost anywhere later without cutting a wall.

The same goes for anything away from the house. If there is a shop, a barn, a gate or a pool house in the plan, or even in the back of your mind, have a conduit put in the ground while the trenches are open for power and water. It is far cheaper than trenching across a finished yard.

Common mistakes

  • Wiring the bedrooms for phones and nothing for Wi-Fi. Phone jacks in every room made sense once. Ceiling drops for access points make sense now.
  • One data cable where two would have cost almost the same. The second cable is nearly free while the first is being pulled.
  • The panel in the attic or garage. Heat shortens the life of network equipment.
  • No cable to the eaves. Cameras end up battery powered, or on visible wire.
  • No photographs. Take a picture of every wall before insulation. In ten years it will tell someone exactly where the wire and the studs are.
  • Calling after drywall. It can still be done. It just costs more and does less.

Room-by-room checklist

Check off what you want, then print the page or take it to your builder. Nothing here is sent to us; the check marks are kept in this browser only.

Where it all lands
Every TV location
Wi-Fi
Security
Cameras and doors
Sound
Desks and everything else

Want it marked on your actual plans? That is what our System Design visit is for, and our builder program covers how we work around a build schedule. The first conversation is free.

Written by the team at Security Solutions, Inc. in Brighton, Tennessee. General guidance, not a quote for your house: every home is different, and we would rather look at yours than guess.

What we install

The services behind this guide.

Where we work

We install from our office at 139 N Main St in Brighton, within about 100 miles. The service areas page lists every town and about how long the drive is.

S.S.I. installs the security systems in all of our new home construction jobs. We are thoroughly impressed with their work and can’t imagine depending on any other company. They’ll always be there for you.

David Tucker, Google review 2 years ago

Free quote

Rather talk it through?

Tell us about the house and we will call you back to set up a free visit. Or skip the form and call the office.

901-476-6918

Security Solutions, Inc.
139 N Main St, Brighton, TN 38011
Toll-free 1-888-280-8775

Request a free quote About a minute

We use these details to reply to your request and for nothing else. Privacy