Customer support

Test the alarm before you need it.

A sensor that has stopped reporting looks exactly like one that works. A test does not take long, and it is the only way to know.

Tell us before you start.

A monitored system sends real signals. Put the account on test first so nobody is sent to your house, and never test by calling 911.

The walk-through

  1. Put the account on test. Call 901-476-6918 and say you are about to test. Client to confirm: how customers place an account on test, and the number to call
  2. Close up and arm. Shut every protected door and window, then arm the system the way you do when you leave.
  3. Open a door. Let the entry delay run out so the siren sounds. It is loud, so warn the household and the dog.
  4. Trip the rest. Open each protected door and window in turn and walk through each room that has a motion detector.
  5. Disarm with your code. The siren stops and the panel shows what was tripped.
  6. Check the list. Open the activity history in the Alarm.com app. Every sensor you tripped should be there by name. Write down any that is missing.
  7. Take the account off test. Call back, confirm the signals arrived, and ask for the account to be put back to normal.

Smoke and carbon monoxide detectors

If yours are tied into the alarm, their test button sends a signal too, so test them while the account is still on test. Hold the button until the detector sounds, then check the app the same way.

How often

Client to confirm: recommended test interval

Whatever the interval, test again after anything changes: a new door, a remodel, new phone or internet service, or a sensor battery swap.

If something did not report

Request service and tell us which sensor. Until it is fixed, that door or room is not protected, so it is worth doing soon.

Adding to your system, or starting a new one?